beautypg.com

2 component access & digit replacement, 3 led drivers, Component access & digit replacement – Daktronics BB-2140 Transparent Shot Clock User Manual

Page 19: Led drivers, N 5.3 )

background image

Scoreboard Troubleshooting

13

Problem

Possible Cause

Solution/Items to Check

Scoreboard works, but some

LEDs always stay on

Short in digit circuit

Swap the digit with one known to

work correctly to verify the problem.

Replace if necessary

(see Section 5.2).

Scoreboard works, but some

LEDs do not light or they

blink

Bad connection

Verify the power/signal connector to

the digit circuit board is secure (see

Section 5.2).

Bad digit or driver

Swap the digit/driver with one known

to work correctly to verify the

problem. Replace if necessary

(see Section 5.2 for digits or

Section 5.3 for drivers).

Scoreboard works, but some

digits do not light

Bad digit or driver

(see solution on previous page)

Incorrect sport code

(see solution on previous page)

Incorrect driver address

(see solution on previous page)

Wrong console controlling

scoreboard

Another console’s radio signal could
be transmitting to the scoreboard.

Radio interference

There may be other radio

transmissions in the area that

overpower the console. If it is not

possible to disable the interfering

device, It may be necessary to run a

wired signal connection instead.

5.2 Component Access & Digit Replacement

Refer to Drawing A-236432 and Drawing A-1060251 in Appendix A for instructions on how
to open the shot clock cabinet and replace the digit panels.

5.3 LED Drivers

LED drivers perform the
task of switching LEDs
on and off. The LED
driver for transparent
shot clocks is located
inside of a separate
control enclosure.

Refer to Figure 5 to view
the location and
components of the
control enclosure.



Figure 5: Driver Enclosure Components