Dual DP295 - Manual (Page 6)

6
You must connect a TV to the DVD system in order to use DVD player. You can connect other audio and audio /
visual components to the DVD system in order to use the Home Cinema Audio system’ s surround sound capabili-
ties.
Important!
- There are various ways to connect the system to a TV (as shown in the illustration). You only need to
make one of best connections.
- Always refer to the instruction manual of the connected equipment to make an optical connection
1 Use the supplied audio cables to connect AUDIO IN jacks to the corresponding AUDIO OUT jacks on the TV or
other audio/visual components.
2 Use the supplied CR/CB/Y cables to connect CR/CB/Y jacks to the corresponding video input jacks on a TV.
If your TV is not equipped with CR/CB/Y video input jacks, you can select one of the following alternative
connections:
Optical 1
Connect the S-VIDEO OUT jack to the S-Video input jack on the TV using a S-Video cable (not supplied).
Optical 2
Connect the VIDEO OUT jack to the video input jack on the TV using a video cable (not supplied).
Use the AUDIO OUT jacks
- For connecting to an amplifier, audio system or TV with analogue audio inputs.
- For connecting to a CD or Type recorde to make an analogue recording.
Use the COAXIAL jacks
- For connecting to an amplifier with DTS, Dolby Digital decoder or CD recorder.
You will need to set the DVD system’ s digital output to “ ALL ” .
Direct Connection with a TV
Connections Connections Connections Connections Connections
COMPONENT
VIDEO OUT
C R C B Y
S-VIDEO OUT COAXIAL VID EO AUD IO
AC ~ 110-220V
50/60Hz
R L OU T