Dual DP295 - Manual (Page 11)

11
* Screen Saver
If set to ON, when you leave the system in stop or
pause mode for more than one minute, the screen
saver will be activated. The default setting is “ OFF” .
Setting the sound
* Digital Output
Digital output selection enalbes you to specify the
type of digital output (COAXIAL) suitable for your
amplifier or reciever.
ALL (defaulting setting )
- Select this item , if you have connected the digital
output to a multichannel decoder receiver.
PCM 96K
- Select this item, if the external component is ca-
pable of processing digital signal input with sam-
pling rates of 96 kHz.
PCM 48K
- Select this item, if the external component is inca-
pable of processing 96kHz digital signal input, then
convert to standard signal with sampling rates of 48
kHz.
OFF
- Select this item, to deactivate the digital output
(COAXIAL output ).
* Night Mode
Set night mode to on to level out the volume. For
example, the disc will play at the same sound level
throughout the movie. The default setting is “ OFF” .
* Test Tone (disc mode only)
If set to ON, the system will test the speaker set-
tings.
The test signal is generated through the left ,
righ t speakers. The default setting is “ OFF ” .
Setting the Language
- Audio
- Subtitle
- Disc Menu
1. This is to select the audio language, subtitle lan-
guage and the language used on TV screen menus
or DVD menus that will always be used for every
disc to be played back. The default setting is “ EN-
GLISH ” .
2. If the language selected is not available on the disc,
the original language designated by each disc will
be selected.
Operations Operations Operations Operations Operations
DIGITAL OUTPUT
NIGHT MODE
CENTER DELAY
TEST TONE
ALL
OFF
OFF
GO TO SOUND SETUP PAGE
AUDIO
SUBTITLE
DISC MENU
ENGLISH
ENGLISH
ENGLISH
GO TO LANGUAGE SETUP PAGE