beautypg.com

3 ad panel mounting, Unistrut attachment, Ad panel mounting – Daktronics FB-2500 Modular LED Football Scoreboard User Manual

Page 13

background image

Mechanical Installation

7

2.3 Ad Panel Mounting

Unistrut Attachment

1. Using the backup channel as a

template, drill four

7

/

16

" holes in

the upper and lower rear flanges
of the ad panel where the beams
will be located.

Note: Try to ensure that the two
center holes will be within the
width of the beam.

2. If the ad panel has backsheets,

remove them as needed to
access the ad panel interior.

3. Attach the piece of unistrut to

the ad panel with the included
hardware, as shown in Figure 9.

4. If any backsheets were removed,

put them back on at this time.

5. Place spring nuts into the unistrut. Twist the spring nuts until they are perpendicular

to the unistrut channel (refer to Figure 5 from Section 2.2).

Once the unistrut is attached and the spring nuts are in place, refer to the appropriate section
below for the type of mounting hardware provided with the ad panel.

Figure 8: Mounting Tube Attachment, Side View

Figure 9: Unistrut Attachment, Side View