Daktronics TI-2020 Multipurpose Track & Field LED Timing Display - Manual (Page 14)

Mechanical Installation 8
3.2 Tripod Mounting
Mounting the display to a tripod requires the optional tripod stand adaptor (part # HS-1306).
A camera tripod is not sturdy enough to safely support the display and will not attach to the
display or adapter plate. An appropriate “speaker stand” tripod is available from Daktronics
(part # A-1580).
The stand adaptor, illustrated in Figure 5, attaches directly to the bottom of the timing
display and to the 1 ½" tube of the tripod.
Daktronics recommends first securing the stand adaptor to the bottom of the display.
Two
5 /
16
" T-bolts included with the kit thread into nuts built into the bottom of the display.
Hand-tighten the T-bolts. With the adaptor attached to the display cabinet, slide the adaptor
over the end of the stand tube and tighten the knob to secure the display to the tripod.
To level the display, loosen the knob and tilt the cabinet backward or forward as needed.
Secure the knob tightly after re-positioning the display.
Figure 5: Tripod Adapter
Threaded nut on
bottom of display
Tripod Bracket
(HS-1306)
Nut
T-bolt
(HS-1315)
O-ring
Knob
Washer