Daktronics FB-2006 Generation III Stackable LED Scoreboard - Manual (Page 23)

Mechanical Installation 17
Once the support beams have been installed, the scoreboard-mounting procedure is
typically a five-step process. Refer to Drawing A-194664 for notes and illustration of the
basic procedure.
1. If you haven't already done so, attach the caption module to the top of the
player/penalty module (MS-2014-11) or to the top of the statistics module (FB-
2006-11.) The caption module is fastened with screws to the top of the powered
module, but it does not attach directly to the beam.
2. Begin the installation by attaching mounting brackets to the top and bottom of
the lowest digit module (the player/penalty section in the MS-2014-11 display,
the shots on goal section in the MS-2018-11 or the statistics digit section in the
FB-2006-11). Fasten the brackets to the modules by inserting 10-24 x 5/8"
screws through the holes in each bracket and threading into the captivated nuts
in the back of the module.
3. With the brackets attached, position the module against the beam and secure it
with the 15"-long threaded rods and the other washers and nuts provided. These
1/2-13 x 15" threaded rods, or mounting bolts, do not go through the beam but
pass along either side; no drilling is required. Refer to Drawings A-194671 and
A-194674. The square nuts go inside the bracket, and the hex nuts are used
inside the rear mounting angles that straddle the back of each support beam.
Tighten the assembly with a 3/4" socket, taking care not to over tighten.
4. Position the clock/score module above the caption module. Attach the mounting
brackets to the clock/score section as described in Step 2, and then secure the
module to the beams with bolts, washers, and nuts, as described in the Step 3.
5. Join the caption and clock/score modules together at the ends by inserting
screws up through the holes in the top of the lower module and into the
captivated nuts in the bottom of the upper module.
For scoreboard models other than MS-2014-11, the building process continues in the
same manner for any remaining modules. Caption modules are attached directly to
their adjoining digit modules and do not accept beam mounting brackets. Refer to
Drawing A-194671.