Daktronics ST-2002 Backlit & Non-Backlit Scorer’s Tables - Manual (Page 10)

4 Display Specifications & Setup
b. Turn the metal hook clockwise to give the latch a tighter fit, or turn the metal hook
counterclockwise to give the latch a looser fit.
c. Make sure the metal hook is pointing downward and then tighten the nut.
2. Lift the table surface approximately 90 degrees and swing the side legs out and into place
underneath. Use the locking slots to secure.
Note: It may be helpful to have two people perform this procedure: one to lift and hold
the table surface and another to position and lock the legs in place.
3. Press down on the leg stops to make sure the table is level on both sides. For further
stability, also lock the rear table wheels.
4. For backlit models (and non-backlit models using convenience outlets), connect the twist
lock power cord to the power-in plug in the lower-right corner of the scorer‟s table, and
then connect the three pin plug to a grounding-type power outlet.