DAHON Service Manual - Manual (Page 22)

NOTE:
Only turn the adjustment bolt in small
increments (e.g. an 1/8 turn) each time,
otherwise it could result in too much
constriction and/or movement.
Index Shifting Adjustment
WARNING:
If you are unsure of how to make
proper adjustments to your bicycle,
seek a qualified bicycle technician for
professional advice on adjustments.
When the LockJaw is unlocked, the frame is
able to rotate around the pivot bolt. Follow the
instructions to adjust (loosen/ tighten) the pivot
bolt. At times, it might be difficult to rotate the
frame due to the pivot bolt being too tight. This
may be a direct result of adjusting the tension
of the pivot bolt, while adjusting the adjustment
bolt.
A 2mm and a 6mm Allen key are needed to
adjust the pivot bolt. The pivot bolt and its lock
screw are on the bike’s non-chain side.
Step 2 (Tighten) - Use a 6mm Allen key
to tighten the pivot bolt by turning it
clockwise. See picture above.
Step 2 (Loosen) - Use a 6mm Allen key
to loosen the pivot bolt by turning it
counter-clockwise. See picture above.
Step 1 - Open the lock screw using
a 2mm Allen key.
Step 3 - When finished close the lock
with a 1 Nm torque.
22