D.T. Systems Micro-iDT PLUS - Manual (Page 14)

14
PROGRAMMING
When adding an “Add-On” collar, the collar will need to
be programmed to the transmitter. If your current collar
unit is not responding to the transmitter, it may also
need to be reprogrammed to the transmitter.
1. Select the desired Collar Selecting Switch position
on the transmitter.
2. Hold the Red Mark (Magnet Indicator) on the
Transmitter directly against the Red Mark (Magnetic
Switch Indicator) on the front of the Collar Receiver.
3. A small red light inside the Collar Receiver will light
up solid for about 1 second, followed by several
flashes. You must keep the Transmitter next to the
Collar Receiver during this time.
4. Continue to hold the Transmitter against the Collar
Receiver until the LED light stays on solid. The Collar
Receiver is now in the Code Running Mode (the LED
light will stay lit for approximately 8 seconds while it is
in this mode).
5. Remove the Transmitter from the Collar Receiver
and press the NICK and CONT buttons
simultaneously while it is in the Code Running Mode.
6. When the LED light blinks 3 times, the Collar ID is
now programmed and the Collar Receiver is now ON.
NOTE – Do not remove the Red Mark on the
Transmitter from the Red Mark on the Collar Receiver
until after the LED light stops flashing and stays on
solid or the Collar Receiver will not go into the Code
Running Mode. You must press the NICK and CONT
buttons simultaneously while the LED light is lit solid.