Dixon ZTR 5601 - Manual (Page 28)

CARE AND MAINTENANCE - 5000 SERIES MODELS
HOT oil may cause burns.
Allow engine to cool before draining oil.
CHANGING THE ENGINE OIL:
1. The "snap lock" oil drain valve is located on the left side of the engine
crankcase.
2. Place a suitable container u nder the drain valve. The fitting of a short piece of hose to the
valve will help direct the oil.
3. Push the valve body in and twist to clear the detent notch.
4. Pulling the valve body outward will start the flow of oil.
NOTE: Refer to engine manuf acturers recommendations for frequency of oil changes.
1. Push the valve body in and twist into the detent notch.
2. Clean any spilled oil from engine and chassis.
3. Refill engine with type, and quantity of oil recommended by the engine
manufacturer in engine literature.
NOTE: Engine oil changes on the 5000 Series Models will require replacement of the oil
filter. These filters can be obtained from any authorized Kohler engine dealer.
PROTECT YOUR INVESTMENT:
The use of non-original oil or air filters may result in damage to the engine and a loss of
warranty. Listed on page 43 are the correct Kohler part numbers for each engine in the
5000 Series.
PLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS
PROTECT YOUR ENVIRONMENT
CAUTION
OIL FILL:
Page 26