Dixon ZTR 5601 - Manual (Page 23)

CARE AND MAINTENANCE - 5000 SERIES MODELS
This portion of the 5000 Series Models owner,s manual deals with normal service items which can be
performed by the owner. Please remember that if you are in doubt as to the correct service procedures to
be followed, these and other service situations can be handled by a Dixon ZTR dealer who is familiar with
the service of your mower.
MAINTENANCE SCHEDULE:
To insure a long and trouble free service life on all the components used on the 5000 Series
Models, a regular and thorough maintenance schedule should be followed. The following
items should be checked after the first (10) hours of operation and on a weekly basis, or
each (40) hours of use: (Items marked with an asterick * require more frequent attention)
1. Drive system, belts and controls.
2. Mower deck belts.
3. Tire pressures.
4. Hydro-Gear oil tank.
5. Tightness of all nuts and bolts.
6. Battery fluid level.
7. * Engine oil. (Before each use or every 8 hours)
8. Electric blade clutch air gap setting.
Before performing any maintenance,
shut off engine, allow to cool.
ENGINE: For engine operating and maintenance information, refer to the engine operating and
maintenance instructions furnished by the engine manufacturer, supplied with each
mower.
BATTERY: Check the fluid in the battery at frequent intervals.
Keep fluid level above the plates in each cell, using distilled water.
OFF-SEASON BATTERY STORAGE:
Identify each cable so cables can be reconnected to correct
terminals.
Disconnect cables from terminals.
ALWAYS disconnect ground cable first and reconnect last.
Charge battery.
DO NOT remove battery from mower.
Clean top of battery and terminals with baking soda and water.
Page 20
CAUTION