beautypg.com

Specifications, Model ztr 5501 – Dixon ZTR 5601 User Manual

Page 11

background image

SPECIFICATIONS

Model ZTR 5501

CHASSIS:

11 GA - rectangular tube

BODY:

Two piece - made of rotational molded polyethylene. Front body contains

access panels for battery service and engine to mower deck belt removal. Rear
body tilts up to allow service on the entire drive system.

SEAT:

Economically designed for operator comfort by use of high density closed cell
foam, contoured back rest and arm rests. Seat is adjustable fore and aft.

MOWER DECK:

12 GA stamped steel construction

3 blades combine for a 50" cut width

Cut height approximately 1.5" to 4.5" via 8 position lift handle

BLADE DRIVE:

Electric clutch

DRIVE SYSTEM:

Each rear wheel is independently driven by a Hydro-Gear BDU-10L Series 70

hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
enclosed Hydro-Gear gearbox.

ENGINE:

20 HP Kohler Magnum, Vertical Crankshaft, 4 -Cycle, Air Cooled, Gasoline, Twin

Cylinder Opposed, Aluminum Crankcase, Removable Cast Iron Cylinder Barrels,
Electronic Ignition, Full Pressure Lubrication.

STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake and blade

drive clutch.

TIRES:

Front 11 X 4 X 5 smooth profile

Rear 20 X 10 X 8 turf savers

RECOMMENDED

Front 16-21

IDS

.

TIRE PRESSURE: Rear 8-14

IDS

.

CAPACITIES:

Fuel - 4.8 gallons total (dual tanks)

Hydrostat oil tank - 3 quart with in-line 10 micron filter
Hydrostat oil recommendation, refer to page 40 Engine - 2
qts. SAE 30 (with filter)

DIMENSIONS: Width

60"

Height

45"

Length

72"

Weight

668 Ibs.

NOTE:

Additional information provided in service instructions under the individual

component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 8