Cybex 12231 VR3 Dip Chin User Manual

Page 13

Cybex Owner’s Manual

3. Slide belt through slot in belt clamp.
4. Verify belt and insert are installed properly. Do not install the insert backwards.

Correct belt routing

Wrong belt routing

Stem

Insert

Stem

Belt

Insert

Belt

5. Pull belt through clamp until input arm measures 31” from floor. Measure from floor to lower

edge of caution decal (located on foot bar).

Foot Bar

31”

Caution Decal

6. Pull belt tight and secure belt to clamp with the two set screws.
7. Torque set screws 300-350 lb-in.
8. Place weight stack pin in each plate to verify proper installation.
9. Simulate normal operation by lifting top weight up and down with out selecting any

resistance.

10. Verify that the belt is moving smoothly and is routed straight from the top pulley bracket to the

the weight belt clamp.

11. Turn the Increment Weight Adjusting Knob to select 0 lbs or 0 kg.

Install back shroud

1. Place shroud into position.
2. Starting at the bottom replace the two BHSCS to secure bottom support bracket to the

shroud.

3. Install but do not tighten remaining BHSCS securing shroud.
4. Tighten all BHSCS.