D-Link WBR-2310 - Manual (Page 29)

29 D-Link WBR-2310 User Manual
Section 3 - Configuration
This will allow you to open a single port. If you would like to open a range of ports, refer to page 30.
Check the box to enabled the rule.
Enter a name for the rule.
Enter the IP address of the computer on your
local network that you want to allow the incoming
service to.
Enter the port that you want to open next to
Private Port and Public Port. The private and
public ports are usually the same. The public
port is the port seen from the WAN side, and
the private port is the port being used by the
application on the computer within your local
network.
Select TCP, UDP, or ANY.
The schedule of time when the Virtual Server
Rule will be enabled. The schedule may be set
to Always, which will allow the particular service
to always be enabled. You can create your own
times in the
Tools > Schedules section.
Virtual Server:
Name:
IP Address:
Private Port/
Public Port:
Protocol Type:
Schedule: