D-Link WBR-2310 - Manual (Page 27)

27 D-Link WBR-2310 User Manual
Section 3 - Configuration
Check the box to enable the DHCP server on your router.
Uncheck to disable this function.
Enter the starting and ending IP addresses for the DHCP
server’s IP assignment.
The length of time for the IP address lease. Enter the Lease
time in minutes.
Also known as Static DHCP - allows the router to assign
the same IP address information to a specific computer
on the local network. The specified computer will get the
same DHCP IP address information every time it is turned
on. No other computer on the local network will receive the
specified static DHCP address except for the configured
computer. Static DHCP is very helpful when used for server
computers on the local network that are hosting applications
such as Web and FTP.
Enable DHCP
Server:
DHCP IP Address
Range:
Lease Time:
DHCP
Reservation:
DHCP Server Settings
DHCP stands for Dynamic Host Control Protocol. The WBR-2310 has a built-in DHCP server. The DHCP Server will
automatically assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be
DHCP clients by setting their TCP/IP settings to “Obtain an IP Address Automatically.” When you turn your computers on,
they will automatically load the proper TCP/IP settings provided by the WBR-2310. The DHCP Server will automatically
allocate an unused IP address from the IP address pool to the requesting computer. You must specify the starting and
ending address of the IP address pool.