Cybex 11030 Eagle Row - Manual (Page 13)

13
Cybex Owner’s Manual
4. Remove lower snap ring and wave washer from the guide rod. Repeat for the opposite guide
rod.
5. Lean guide rods outward, away from machine in order to provide the most room for installing
weight plates.
6. Slide top weight/second plate up and out of machine and carefully set it aside.
7. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight
automotive engine oil.
8. Install each weight plate one at a time. When installing weight plates, position plates so wide
edges of bushing face upward and narrow edges of bushing face downward.
NARROW
bushing edge
WRONG
WIDE bushing
edge faces
upward
CORRECT
NOTE: The narrow
bushing edge must
face downward.
9. Slide top weight/second plate onto guide rods.
10. Place lower snap ring and wave washer onto guide rod (about 3” from the top end of guide
rod.)
11. Raise guide rod up through mounting hole and install the upper snap ring.
12. Lower guide rod and secure lower snap ring. Repeat for the opposite guide rod.
Belt Routing
1. Verify belt is routed through top of pulley bracket and then route end of belt down to the top
weight.
2. Lift top weight and verify that the position of the belt clamp (on the top weight) is aligned
properly with the top pulley bracket (on the machine.)
Top Pulley
Belt
Insert and Set Screws (not
shown) are on this side.
Increment
Weight
Adjusting
Knob