Cybex 11030 Eagle Row - Manual (Page 11)

11
Cybex Owner’s Manual
15. Remove the six BHSCS securing the two halves of the frame.
BHSCS (qty 6)
Nylon Locknut (6)
16. Lay the taller half of the frame down on the floor until you are ready to move it.
17. Move each half through the doorway to the desired location. Again, lay the taller half of the
frame down on the floor until you are ready to reattach the two halves.
18. Attach each half together using the six BHSCS removed.
BHSCS (qty 6)
Nylon Locknut (6)
19. With the flat part facing down, carefully slide the pulley shaft back into the machine.
20. Slide the pivot shaft through the pulley shaft.
21. Secure the pivot shaft using the BHSCS.
22. Reconnect the pulley to the pulley bracket.
23. Verify the two belts are routed properly (one belt connecting from the cam to the pulley
bracket and the other belt connecting from the pulley to the arms.)
24. Connect the weight stack belt to the belt clamp of cam (removed earlier.)
Set
Screws
Cam
Install rubber feet
1. Remove each (standard) cone-shaped shipping support using a 3/4” socket or wrench.
2. Cut shipping tie securing top weight.