Cybex 11020 Eagle Incline Pull - Manual (Page 14)

14
Cybex Owner’s Manual
3. Slide belt through slot in belt clamp.
4. Verify belt and insert are installed properly.
Correct belt routing Wrong belt routing
Stem
Belt
Insert
Stem
Belt
Insert
5. Pull belt tight and secure belt to clamp with the two set screws. Torque set screws 300-350
in-lbs.
Belt clamp
Belt Belt clamp
insert
Set screws
6. Place weight stack pin in each plate to verify proper installation.
7. Without selecting any resistance, lift top weight up and down (simulating normal operation.)
8. Verify that the belt is moving smoothly and is routed straight from the top pulley bracket to the
weight belt clamp.
9. Reinstall the six increment weights that were removed.
WRONG
CORRECT
Increment
Weights
10. Turn the Increment Weight Adjusting Knob to select 15 lbs.