Cybex 18020 Bravo Pull - Manual (Page 6)

6
Cybex 18020 Bravo Pull Owner’s Manual
Securing Equipment
Do not use machine until it is properly anchored.
The machine has holes in the feet, which allow for ease in anchoring to the floor. All anchoring holes
must be used to maximize stability. Equipment must be secured to a solid, level surface to eliminate
rocking, tipping, or falling over due to incorrect usage and misuse.
The solid, level surface should not deviate more than 1/8” over a 10’ distance or as defined and
required by local building and architectural codes.
Anchoring of equipment must be completed by a qualified licensed contractor.
Due to the wide variation of flooring on which machines may be anchored or installed, verify
anchoring method and anchoring fasteners with a qualified and licensed contractor.
A minimum pull out force of 220 lbs/100 kgs is required for each anchor position.
PROPER USAGE
Use equipment only as described in the manual or on the placards located on each machine. Failing
to follow proper instructions may result in injury.
STANDARD COMPLIANCE
Cybex products meets applicable ASTM and EN Standards.
Regular Maintenance Activities
Preventative maintenance activities must be performed to maintain normal and safe operation of your
equipment. Keeping a log sheet of all maintenance actions will assist you in staying current with all
preventative maintenance activities. The preventative maintenance actions are described in detail in
the maintenance section of this manual. Briefly, they include:
Daily
Clean upholstery.
Weekly
• Inspect all nuts and bolts for looseness. Tighten as required.