COWON SP2 - Manual (Page 6)

COWON SP2 23
1 Volume Up(+) 7 Microphone
2
Previous Song /
Fast Rewind
8 LED Status Indicator
3
Play / Pause,
Pairing
9
ON / OFF Button :
Power Switch
4 Volume Down(-) 10 AUX-IN Port
5
Next Song /
Fast Forward
11 USB Port
6 NFC Sensor 12 USB Cable
Before Using This Product
+ Charging
1. Plug the USB cable into the USB port of a PC.
2. LED indicators display the battery charge status.
- Red light on : Charging
- Red light off : Finish charging
3. It takes about 3 hours to finish charging.
- COWON SP2 can also be charged by a Micro USB smart phone charger.
- For normal charge, please turn off SP2.
- When charging SP2 for the first time or if SP2 has not been charged for an
extended time, fully charge the battery before use.
- When the battery is low, SP2 emits a string of warning tones every 1 minutes and
the red LED flashes. Please recharge the battery of the speaker.
- SP2 may not be charged properly when it is connected to a USB hub. Please
connect SP2 directly to a USB port on the back of a PC.
+ Turning On / Off SP2
Functions Operation LED indicator Prompt tone
Turning on
Make the power
switch ON
Blue LED on
one second
4 rising tones
Turning off
Make the power
switch OFF
Red LED on
one second
4 falling tones
+ How to Enter Pairing Mode
■ How to enter pairing mode
Ensure SP2 is on. If not, please turn it on first and press ▶ll button long
about 4~6 seconds until red and blue LEDs flash alternately.
Using This Product
- Pairing mode will last 2 minutes. If no devices can be connected after 2
minutes, it will return to standby mode automatically.
- If SP2 does not play music even though it has already connected with a
device, press ▶ll button long to enter pairing mode.
- You will hear 2 rising tones when SP2 enters pairing mode.