Dukane Data Video LCD - Interactive WXGA UST Projector 8107HWI - Manual (Page 14)

12
Turning off the power
1. Press the STANDBY/ON button on the
projector or the remote control.
The message “Power off?” will appear on
the screen for about 5 seconds.
2. Confirm that there is nothing that the
lens door hits while closing. Press the
STANDBY/ON button again while the
message appears.
If the pen sensor is within easy reach, attach
the sensor cover provided to keep it from
getting dusty.
The projector lamp will go off, and the
POWER indicator will begin blinking in
orange. The lens door will close right after the
lamp goes off.
However, to maintain better picture quality, the
lens door will close after the lamp has been
cooled down when the projector is installed
upside down such as in ceiling mount installation. Then the POWER indicator
will stop blinking and light in steady orange when the lamp cooling is complete.
Do not turn the projector on for about 10 minutes or more after turning it off.
Also, do not turn the projector off shortly after turning it on. Such operations might
cause the lamp to malfunction or shorten the lifetime of some parts including the lamp.
VIDEO DOC.CAMERA
KEYSTONE
ASPECT SEARCH BLANK
MUTE MY BUTTON
POSITION
1 2
ESC
ENTER
MENU
RESET
COMPUTER MY SOURCE/
AUTO
MAGNIFY VOLUME
࡯
ON
OFF
㧗
FREEZE
FOCUS D-ZOOM - + - +
PAGE UP
DOWN
WARNING ►Be careful not to pinch your finger with the lens door, to
prevent an injury.
►Do not touch around the lamp cover and the exhaust vents during use or just
after use, since it is too hot.
►Remove the power cord for complete separation. The power outlet should be
close to the projector and easily accessible.
NOTE • Please power off the projector after any connected devices are
powered off.
• This projector has the AUTO POWER OFF function that can make the
projector turn off automatically. For more information, please see the “Operating
Guide” in the CD.
STANDBY/ON button
POWER indicator