Delta TP300 - Manual (Page 4)

4
ADDITIONAL SAFETY RULES FOR PLANERS
FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY
SAVE THESE INSTRUCTIONS.
Refer to them often
and use them to instruct others.
1. DO NOT OPERATE THIS MACHINE until it is
assembled and installed according to the instructions.
2. OBTAIN ADVICE FROM YOUR SUPERVISOR,
instructor, or another qualified person if you are not
familiar with the operation of this machine.
3. FOLLOW ALL WIRING CODES and recommended
electrical connections.
4. MAKE all adjustments with the power off.
5. DISCONNECT machine from power source when
making repairs.
6. NEVER turn the planer “ON” before clearing the
table of all objects (tools, scraps of wood, etc.).
7. KEEP knives sharp and free of all rust and pitch.
8. NEVER perform any planing operation with guard
removed.
9. KEEP fingers and hands away from cutting area.
10. NEVER reach under the cutterhead while the machine
is running.
11. KEEP fingers and hands away from chip exhaust
opening. The cutterhead rotates at extremely high speeds.
12. NEVER feed the work into the outfeed end of
machine.
13. ADEQUATELY support the workpiece at all times.
14. WHEN planing extra long workpieces, MAKE SURE
the material is supported at the infeed and outfeed end
at table height.
15. NEVER start the machine with the workpiece in
contact with the cutterhead.
16. MAKE SURE the workpiece is free from nails and
other foreign objects which could cause injury or
damage to the blades.
17. MAKE SURE the blades are properly secured in the
cutterhead, as explained in the instruction manual, be-
fore turning on power.
18. ALWAYS allow the cutterhead to reach full speed
before using.
19. IF DURING OPERATION there is any tendency for
the tool to tip over, slide or walk on the supporting
surface, MAKE SURE TOOL IS SECURED TO THE
SUPPORTING SURFACE.
20. DO NOT perform planing operations on material
shorter than 10 inches, narrower than 3/4 inches, wider
than 12 inches, or thinner than 3/16 inches.
21. BEFORE LEAVING the machine, make sure the work
area is clean.
22. TURN THE MACHINE “OFF” AND DISCONNECT
THE MACHINE from the power source before installing
or removing accessories, before adjusting or changing
set-ups, or when making repairs.
23. TURN THE MACHINE “OFF”, disconnect the
machine from the power source, and clean the
table/work area before leaving the machine. LOCK THE
SWITCH IN THE “OFF” POSITION
to prevent
unauthorized use.
24. ADDITIONAL INFORMATION regarding the safe and
proper operation of power tools (i.e. a safety video) is available
from the Power Tool Institute, 1300 Sumner Avenue,
Cleveland, OH 44115-2851 (www.powertoolinstitute.com).
Information is also available from the National Safety Council,
1121 Spring Lake Drive, Itasca, IL 60143-3201. Please refer
to the American National Standards Institute ANSI 01.1
Safety Requirements for Woodworking Machines and
the U.S. Department of Labor OSHA 1910.213
Regulations.