Comtech EF Data LPODnet - Manual (Page 38)

LPODnet M&C Netbook Accessory Revision 3
Ethernet-Based M&C using the LPODnet MN-LPODNET
3–8
3.5.1.2 Summary of Remote Control Commands and Queries
Table 3-1 on the next page summarizes the remote commands and queries available for the
SSPA. Full explanations of functionality are provided in Chapter 5. SERIAL-BASED REMOTE
PRODUCT MANAGEMENT in the pertinent SSPA manual (CEFD P/N MN-LPOD or MN-SPODPSX).
• Column ‘C’ = Command.
• Column ‘Q’ = Query.
• Columns marked ‘
X
’ designate that instruction code as Command only, Query only, or
Command/Query.
• Where an Instruction Code is noted XXX E this denotes a command/query designated as
End-of-Life (EOL). While these commands are fully supported in this product it is highly
recommended that the equivalent new commands are used for new implementations.
• Where an Instruction Code is noted XXX O this denotes a command/query that is
available only when a reference oscillator is installed.