Comtech EF Data CME-5200 Manual - Manual (Page 32)

CME-5200 Digicast Media Router ASI Receiver Revision A
Device Management via User Interfaces MN/MRASIRCDC.IOM
4.3 Terminal Interface
The Terminal Interface provides the user with a textual configuration dialog for
configuring the ASI-R. This method of configuration should be used for initial
configuration of the unit; i.e., configuring the network parameters for the unit but not for
normal operation. The Web (HTTP) Interface is recommended for operational
management.
The Terminal Interface allows the entire unit to be configured and managed, but this
interface can only be used while a serial connection is present between the ASI-R and a
PC. The screens shown in this section are displayed via a Telnet connection.
The same menu information is displayed via the serial interface with some specific
features only available via this access method – these ‘serial interface only’ features are
noted in this section. Detailed information is provided about the menu features in
Chapter 4.2 Web Interface.
Figure 4-10. Menu Hierarchy (via Terminal Interface)
Figure 4-10 shows the hierarchal structure of the Terminal Interface-based menus, and
the sections in this chapter which provide figures of these submenu pages.
Once the terminal interface is connected, as described in Chapter 2.4 Initial
Configuration, press the
key . The user should observe the the Main Menu as
shown in Figure 4-11.
Administration
Menu (4.3.3)
Unicast Routing
Config Menu (4.3.5)
See Figure 4-19
for hierarchy
MPEG TS Config
Menu (4.3.7)
IGMP Configuration
Menu (4.3.4)
Stats Menu
(4.3.8)
Network Configuration
Menu (4.3.2)
PID Configuration
Menu (4.3.6)
Main Menu
(4.3.1)
4-10