Comtech EF Data RRS11 - Manual (Page 27)

MN-RRS11 5–1
Rev. 3
Chapter 5. Technical
Specifications
5.1 RRS11 and RRS11 L Technical Specifications
5.2 Introduction - RRS11 L-Band Switch
This section defines the technical performance parameters and specifications for the Solid-State
Transfer Switch. The RRS11L is intended to operate with the DM240-PIIC or DM240XR
modulators.
5.2.1 General Specifications
RRS11-L L-Band Configuration: DM240-PIIC OR DM240XR only
Switch Time: 50 msec Maximum
Rear Panel Ports: L-Band input: J7 - SMA, 50 ohm (mod A)
L-Band input: J8 – SMA, 50 ohm (mod B)
L-Band output: J6 – N-type, 50 ohm (online)
L-Band output: J9 – N-type, 50 ohm (offline)
L-Band Monitor input: J4 - SMA, 50 ohm (Mod A)
L-Band Monitor input: J5: - SMA, 50 ohm (Mod B)
Front Panel Ports:
L-Band Monitor output: BNC 50 ohm (Mod A)
L-Band Monitor output: BNC 50 ohm (Mod B)
L-Band Monitor output (online)
L-Band Monitor output (offline)
Control Ports:
DB-9 Male: J2 (prime)
Status Port: DB-9 Male: J3 (backup)
Return Loss: SMA: 14 dB (L-band input)
N-Type: 14dB (L-band output)