Comtech EF Data STS11/STS11L - Manual (Page 16)

STS11/STS11L Solid-State Transfer Switch Revision 0
Installation MN-STS11-11
2–2
2.2 Unpacking
The STS11/STS11L Solid-State Transfer Switch was carefully packaged to avoid damage
and should arrive complete with the following items for proper installation:
• STS11 or STS11L Solid-State Transfer Switch Unit
• STS11 or STS11L Test Data Sheet
• Interconnect Cables and Materials as Required
• Mounting Brackets
• Installation and Operation Manual
2.3 Test Data Sheet
Each STS11/STS11L Solid-State Transfer Switch is shipped with a Test Data Sheet.
This report contains information on the results of the Switch quality control testing. The
report also includes information pertaining to the system settings that were made at the
factory. Radyne Inc. recommends that the user save this report for future reference.
2.4 System Connections
For initial Solid-State Transfer Switch setup and configuration, perform the following
procedure:
1) Interconnect the units as shown in the figures below.
2) Proceed to Section 4, User Interface for information on the Solid-State Transfer
Switch controls and indicators.
2.5 Connecting to DM240-PIIC Digital Modulators
Figure 2-1 illustrates the cable connections between the STS11 and two DM240-PIIC
units. Refer to Table 2-1 for cable part numbers.