Compuprint MDP40B User Manual
Page 47
43
Setup Parameter
Values
Description
RESET WITH EJECT
no, yes
When the printer receives a reset command, selecting
yes
it
ejects the paper, selecting
no
it performs only the reset
command. Setting used for the OLIVETTI protocols.
LINE MODE
LF=LF, CR=CR
CR=LF+CR
If the printer receives a LF code (LF), it only performs a line feed.
If the printer receives a CR code (CR), it only performs a
carriage return.
If the printer receives a CR code (CR), it performs a carriage
return followed by a line feed. If the printer receives a LF code
(LF), it performs a line feed.
LF=LF+CR
LF&CR=LF+CR
If the printer receives a LF code (LF), it performs a line feed
followed by a carriage return. If the printer receives a CR code
(CR), it only performs a carriage return.
If the printer receives a LF code (LF) or a CR code (CR), it
performs both a line feed and a carriage return.
WRAP MODE
truncate, autowrap
The data exceeding the line length are truncated (
truncate
) or
printed on the following line (
autowrap
).
SLASHED ZERO
no, yes
Selects the printing character for zero, with a slash (
yes
) or
without (
no
).
PRINT DIRECTION
unidir., bidir., sw
control
Selects the printing direction of the print head: unidirectional
(
unidir
.), bidirectional (
bidir
.) or selected via software (
sw
control
).
EJECT ON FF
no, yes
Performs a form feed according to the selected page format (
no
)
or ejects a cut sheet loaded into the printer (
yes
).