Compuprint 2056 - Manual (Page 33)

User Manual 2056
MAN10xxx-01 25
1. Turn on the printer. Pull the paper-select lever to tractor paper mode, press LOAD/EJECT
key to load tractor paper.
2. Press ONLINE key to ensure the ONLINE LED blinks. Hold on pressing ONLINE key for
about 3 seconds till the printer beeps once. The ONLINE LED and PAPER OUT LED blinks
alternately.
3. Press LF/FF and LOAD/EJECT keys to adjust the printing home position.
4. Press the ONLINE key again to save and quit the alternate mode after finishing adjusting.
The operation step of adjusting the tear position is generally the same with that of the
printing home position. But the exclusive difference is pressing TEAR to feed paper to the
tear position after installing the tractor paper.
2.4.6 Feed Paper to the Tear Position
1. Turn on the printer; hold the ONLINE key for 3 seconds when offline till the ONLINE
LED blinks with a beep.
2. Hold the TEAR key for 3 seconds that you can switch the function of feeding paper to
the tear position to ON or OFF automatically.
2.4.7 Other Functions of the Control Panel
KEY FUNCTION
ONLINE + POWER
Print current setting mode; If long press the
LOAD/EJECT+ LF/FF
keys down in online mode, the
printer would enter menu setup mode.
POWER + LOAD/EJECT
Chinese self-test mode
TEAR + POWER
ASCII self-test mode
TEAR + LF/FF + POWER Hex dump mode
LF/FF + POWER
Pin test mode, which is to test whether the print pins are in
good condition.
Note: Don't revolve the paper feed knob when the printer is in the process of the
micro-adjust.
Note: The adjustable range of printing home position is from -18/60 inch to
+60/60 inch (based on the factory default setting).
The adjustable range of tear position is from -15/60 inch to +15/60 inch
(based on the factory default setting).
Note: Don't press SPEED key now, or the printer can’t enter the micro-adjust mode.