Code Blue CB 2-E ECONOMICAL WALL MOUNT HELP POINT - Manual (Page 5)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-149-G page 5 of 43
CB 2 Series
Administrator Guide
3 Getting Started
Basic Install Instructions
1. EIA/TIA, ANSI, CSA and BICSI cabling or similar standards shall be adhered to for proper
operation of Code Blue communication devices connected to copper or fiber infrastructures.
Communications cable and electrical cable in the same conduit is not an acceptable instal-
lation and shall not be supported. Analog phones require a minimum of 23mA for proper
operation (26-29mA recommended).
2. Each analog speakerphone requires its own phone line or PBX extension. Multiple units
shall not be supported.
3. Speakerphones require programming before operation. Consult the User Guide or
Administrator Guide enclosed with the unit or visit www.codeblue.com > Support >
Downloads to read or download manuals.
4. If you are installing IP speakerphones, please read the appropriate manuals and consult
with your Network Administrator.
5. Size electrical wiring based on length of run.
6. Consult the enclosed document packet for internal wiring instructions.
Tools Required
CB 2 Series
1. Drill and security bit for removing and inserting security screws on phone and access plate
2. Phillips head screwdriver and flat head screwdriver
3. 3/8 socket set to mount unit onto wall