beautypg.com

Cb 4 series – Code Blue CB 4-S SIGNATURE WALL/POLE MOUNT ENCLOSURE User Manual

Page 31

background image

Code Blue

259 Hedcor Street

Holland, MI 49423 USA

800.205.7186

www.codeblue.com

GU-160-C

page 31 of 45

CB 4 Series

Administrator Guide

19 CB 4 Series Pole Mount Installation Instructions

1.0 THREAD MOUNTING STRAPS THROUGH SLOTS – Use outside slots for larger poles and inside

slots for smaller poles.

2.0 HOLD BRACKET TO POLE – Set the height of the bracket (C) so that the speakerphone push

button(s) on the unit will be at desired height (please check with local codes for ADA compliance).

3.0 BAND THE BRACKET TO THE POLE AT DESIRED HEIGHT

3.1 To eliminate waste, pull band

(A) from carton as needed. With ears of buckle (B) away from

operator, slide the buckle on the banding. Lace banding around the object being clamped and

again through buckle.

3.2 Bend end of band under buckle.

3.3 Slide band in tool nose slot. Press down on gripper with thumb and tension clamp by turning

the handle. Maximum tension has been reached when the band stops moving through the

buckle.

3.4 When maximum tension has been reached, roll tool over buckle, at same time reversing handle

carefully at approximately three-quarters turn to avoid breakage. The band that is released will

be used in the bend and therefore there is no loss of tension.

3.5 Lift cutter lever and the band will be cut to correct length.While holding the stub of the band

with your thumb, hammer flat over bridge of buckle.

3.6 Complete application by hammering the buckle ears over the stub.

4.0 ATTACH ENCLOSURE TO BRACKET

4.1 Place a rubber washer

(D) on each of the four studs.

4.2 Align and place the back plate of the unit over the four studs.

4.3 Place a second set of rubber washers on each of the four studs (inside the unit).

4.4 Place a steel washer

(E) on each of the four studs.

4.5 Turn a nut

(F) on each of the four studs.

Specifications subject to change without notice or obligation on the part of the manufacturer.

Banding tool sold

separately on the

Parts Order Form,

part #41441.