Code CR2500 Code FIPS User Manual
Page 7
C005590_01_CR2500_CR3500_User Manual_Appendix H
6
•
CO Authenticated – the module will indicate this mode of operation by blinking the blue Left LED light in
a 1 second on, 1 second off pattern.
•
Un-Authenticated – the module will indicate this mode of operation by blinking the blue Left LED light in
a 2 seconds on, 1 second off pattern.
•
Reader Authenticated – the module will indicate this mode of operation by blinking the blue Left LED
light in a Morse Code ‘F’ pattern. The Morse Code ‘F’ is comprised of two short dots, a long dash and a
short dot (
F
) followed by a 3.5 second delay.
•
Error State – The LED lights will blink (.5 seconds on, .5 seconds off) red to indicate there has been an
error in FIPS processing. Clear the error by power cycling the reader by removing and replacing the
battery.
CR3500 FIPS Reader -
The CR3500 module indicates FIPS mode in three stages. The three stages are:
•
CO Authenticated – the module will automatically indicate this mode of operation by displaying Packet
Mode Icon of the letter ‘FA’ on the top line of the reader display as shown in Figure 3 below.
•
Un-Authenticated – the module will automatically indicate this mode of operation by displaying Packet
Mode Icon of the letter ‘FR’ on the top line of the reader display as shown in Figure 4 below.
•
Reader Authenticated – the module will automatically indicate this mode of operation by displaying
Packet Mode Icon of the letter ‘F’ on the top line of the reader display as shown in Figure 5 below.
•
Error State – The LED light will blink (.5 seconds on, .5 seconds off) red to indicate there has been an
error in FIPS processing. Clear the error by power cycling the reader by removing and replacing the
battery.
Figure 3 – CR3500 FIPS CO Authenticated Status Indication
Figure 4 – CR3500 FIPS Un-Authenticated Status Indication
Figure 5 – CR3500 FIPS Reader Authenticated Indication
CodeXML® FIPS Bluetooth® Modem
•
CO Authenticated – the module will indicate this mode of operation by blinking the LED light in a 1
second on, 1 second off pattern.