Cloud Electronics CDI-S100 - Manual (Page 8)

CDI-S100 Installation Guide v1.0 8
GENERAL FORMAT
FUNCTION COMMAND (ASCII)
Select Line Input x as music source x/>
Select next higher-numbered Line Input
Select next lower-numbered Line Input
Set music level to –(m/2) dB relative to max volume m/>
Reduce music level by (p/2) dB p/>
Increase music level by (q/2) dB q/>
Mute music
Unmute music
Mute microphone y y,M/>
Unmute microphone y y,O/>
Set master mic level to –(m/2) dB relative to max volume m/>
Reduce master mic level by (p/2) dB p/>
Increase master mic level by (q/2) dB q/>
Mute all microphones
Unmute all microphones
Examples:
1. Input selection
To directly select a specific music source, the value of x in the general format is the number of the
Line Input (1 to 6) selected as the music source. Note that x can also be set to zero to positively
de-select all music sources.
Alternatively, the music sources may be “stepped through” one at a time (in either direction),
using the increment or decrement commands. If an increment command is received when Line In
6 is already set, the command is ignored. If a decrement command is received when Line 1 is set,
no music source is selected (equivalent to the “Line 0” command mentioned above). Any further
decrement commands are ignored
EXAMPLE
COMMAND
(ASCII)
COMMAND (HEX)
Select Line Input 3 3C 4D 55 2C 53 41 33 2F 3E
Select Line Input one above current 3C 4D 55 2C 53 55 2F 3E
Select Line Input one below current 3C 4D 55 2C 53 44 2F 3E