CITIZEN 085X - Manual (Page 6)

USER’S GUIDE
© 1999 Citizen Watch Company Europe Internet http://www.citizenwatch.de CITIZEN WATCH EUROPE GmbH
Hans-Duncker-Strasse 8, D-21035 Hamburg
Tel. 040/734 62-277/278/279
CAL. No.
C C5 50 0
Features include:
• ANALOG AND DIGITAL DISPLAY
• DUAL DIVE DISPLAY
• AUTOMATIC CALENDAR
• DAILY ALARM
• 24 HOUR, 1/100 SECOND CHRONOGRAPH
• DIVE LOG MEMORY
• DEPTH ALARM
• DIVE TIME ALARM
• PRESSURE SENSOR
• WATER SENSOR
• TEMPERATURE SENSOR
• RAPID ASCENT ALARM
SETTING INSTRUCTIONS
TO SWITCH MODES
Press and release M, modes will be changed in the following sequence: Time/Calendar (or seconds), Alarm, Chronograph, Dive
Log and Dive Alarms.
TO SET DIGITAL TIME
(Set analog time after digital is set) Depress B for 3 seconds, seconds will flash. Press and release A, seconds will reset to '00'
and start counting upward again. Press B, minutes will flash. Use A to advance minutes. (hold down for rapid advance) Press
B, hours will flash. Use A to advance hours. ( If in 12 hour mode check for A or P to indicate AM or PM). Press B, month num-
ber will flash. Use A to advance month. Press B, date will flash. Use A to advance date. Press B, year will flash. Use A to
advance year. Autocalendar is self-correcting through the year 2099. Press B, 12H/24H will flash. Use A to select 12H for AM/PM
time or 24H for military time. Press B to finalize digital time setting.
TO SET DAILY ALARM
Press M to move display to alarm mode. Depress B for 3 seconds, hours will blink and ON/OFF display will show ON. Use A to
advance hours. Pay attention to A (AM) or P (PM) unless time display is in military time (24H). Press B, minutes will flash. Press
A to advance minutes. Press B to finalize setting. While in alarm mode, press A to activate or deactivate alarm (ON/OFF).
TO CHECK DIVE LOG
Move display to dive log mode by pressing M. First items displayed show the dive number (upper) and month and date (lower)
of the last dive for 3 seconds and then switches to maximum depth of the last dive in the upper display and the elapsed time
(total time) of the last dive in the lower display. Press A, log display shows the average depth of the last dive (upper) and, the
lowest water temperature during the last dive (lower).
TO SET DIVE ALARMS
Move display to dive alarm mode (D.A.L.) by pressing M. Upper display now shows depth alarm setting and lower display shows
dive time alarm setting. Depress B for 3 seconds, depth figure begins to flash, and lower display changes to number of times
during the dive you want depth alarm to sound. Press A to increase depth alarm setting in 3 foot increments. Hold A down for
rapid advance. Press B, 'number of times you want depth alarm to sound during the dive' will flash. As A is pressed, figure will
change in the following sequence: ON, OFF, -1-, -2-, -3-. -4- and -5-. When selection is made, press B, lower display changes
back to dive time alarm figure (flashing). Press A to increase dive time in 5 minute increments; maximum 95 minutes. Press B
to finalize dive alarm settings. Press M to return to time/calendar.
For further instructions, see instruction manual.
MODELS: MA9004-21E HYPER AQUALAND