CITIZEN 085X - Manual (Page 11)

USER’S GUIDE
© 1999 Citizen Watch Company Europe Internet http://www.citizenwatch.de CITIZEN WATCH EUROPE GmbH
Hans-Duncker-Strasse 8, D-21035 Hamburg
Tel. 040/734 62-277/278/279
CAL. No.
D D2 20 06 6
Features include:
• DEPTH DISPLAY AND MEMORY UP TO
260 FT.
• WATER TEMPERATURE DISPLAY AND
MEMORY
• ELAPSED DIVE TIME MEMORY
• DIVE LOG MEMORY FOR UP TO 30 DIVES
• ALARMS FOR ASCENT RATE AND LOW
BATTERY
• SCREW-BACK CASE
• 200 METER WATER RESISTANT
SETTING INSTRUCTIONS
TO SET TIME AND CALENDAR
Press and release M until dot indicator (mode) window displays TIME. Press and hold B for 3 seconds or until seconds blink.
Press and release A to reset seconds to zero. Press and release B, minutes will blink. Press A to correct minutes (hold button
down for rapid advance). Press and release B, hours, AM or PM will blink. Press A to correct hours and AM/PM. Press and
release B, month number will blink. Press A to correct month. Press and release B, date will blink. Press A to correct date. Press
and release B, day of week will blink. Press A to correct day of week. Press and release B, year will blink. Press A to correct
year. Press and release B, 12H or 24H will blink. Press A to select 12 or 24 hour time display. Press and release B to finalize
time/calendar setting.
TO SET ALARM TIME
Press and release M until dot indicator (mode) window displays ALM. Press and hold B for 3 seconds or until alarm hours blink.
Press A to correct alarm hours. Press and release B, alarm minutes will blink. Press A to correct alarm minutes. Press and
release B to finalize alarm time setting. Press and release A while in alarm mode (steady display) to switch alarm on or off. If
alarm time is shown alarm is on. While A is depressed alarm sound can be checked.
TO DISPLAY AIR TEMPERATURE
While watch is in Time/Calendar mode, press and release A. Dot indicator (mode) window now displays TEMP. Watch samples
air temperature every 10 seconds for the first 3 minutes, at 30 minute intervals thereafter. Accurate air temperature can be
obtained only after watch is off the wrist for 20 to 30 minutes.
DIVE LOG MODE (Dive Memory)
Press and release M until dot indicator (mode) window displays LOG or PLOG. If no dive data have been recorded, display will
show only LOG and dashes where data should be. If a valid dive has been recorded in the memory, display will show PLOG and
dive profile data can be transferred.
ADDITIONAL MODES
Dive mode is automatically activated and begins to display at 4 feet. Surface mode is automatically activated after a valid dive
is finished. Transfer mode may be used only after a valid dive has been stored in the memory (PLOG).
For further instructions and a description of the many additional features of Hyper Aqualand, see instruction manual.
MODELS: MA9004-21E HYPER AQUALAND