CITIZEN 085X - Manual (Page 5)

USER’S GUIDE
© 1999 Citizen Watch Company Europe Internet http://www.citizenwatch.de CITIZEN WATCH EUROPE GmbH
Hans-Duncker-Strasse 8, D-21035 Hamburg
Tel. 040/734 62-277/278/279
CAL. No.
B B7 74 4
Features include:
• SOLAR-POWERED
• DEPTH SENSOR
• DEPTH INDICATOR HAND
• ELAPSED-TIME BEZEL
• WATER SENSOR
• 50 MINUTE CHRONOGRAPH
• 200 METER WATER-RESISTANT
• RESERVE POWER INDICATOR
• RECHARGEABLE BATTERY
SETTING INSTRUCTIONS
TO SET TIME
• Unscrew the crown by burning it in a counterclockwise direction to release it. Pull the crown out two steps to set the hour and
minute hands. Turn the crown to move the hands forward to correct the time while observing the 24 hour hand so as to proper-
ly set the time for AM or PM. Push the crown in to finalize setting.
TO SET DATE
• After the correct time has been set (24hour hand indicating whether time is AM or PM) and the crown is pulled out one step
(intermediate position), rotate the crown in the counterclockwise direction to set the date. Push crown in against the case and
while continuing to apply pressure, turn the crown clockwise until it is screwed tightly against the case.
CHANGING MODES
• To switch to the chronograph mode while in normal time display mode, (mode hand on DV), press and hold down A for 2 sec-
onds and mode and function hands move to zero position.
• To switch back to normal time display mode from chronograph mode, press and hold A for 3 seconds. Watch switches to dive
standby mode automatically when water sensor is wet. To switch back to time after dive, press and hold B for 3 seconds.
• To call up maximum depth memory of the last dive, while in the time or dive mode, press B. Depth indicator hand will move to
show the deepest point of the last dive. Press and release B again to return the depth hand back to its previous position.
TO USE CHRONOGRAPH
• Hold A down for 2 seconds while in normal time display mode to switch to chronograph mode. Function hand now becomes
chronograph sweep second hand, mode indicator hand becomes minute register hand and small second hand always shows
running seconds.
• Press and release B to start or stop chronograph. When stopped, press A to reset hands to zero. If either of the two hands
does not index to zero, please see 'all reset' not e in the instruction manual. To return to normal time display mode from chrono-
graph mode, press and hold A.
• Chronograph does not operate simultaneously with time or dive mode, so if mode is switched from chronograph, chronograph
data is deleted.
TO USE DEPTH METER
• Watch will automatically switch to dive standby mode from either normal time or chronograph mode whenever water sensor
gets wet. Mode hand moves to 'DV' and depth indicator hand will move to '0' feet. (If not, please refer to instruction manual for
'all reset' procedure). Before the watch goes to dive standby mode and before diving, make sure 'screwlock' crown is tightened
securely against the case. Watch is now ready for diving.
• To read the maximum depth memo for the last dive (after the watch is dried off), press B while in time or dive mode and depth
indicator hand will point to the r maximum depth of the last dive. Press B again to return to the previous mode.
• Depth meter and chronograph cannot be used simultaneously so please use the elapsed-time indicator (ETI) bezel ring to keep track
of elapsed dive time.(See instruction manual). It is recommended that there be o diving unless power level indicator is at level 2.
For further instructions, see instruction manual.
MODELS: BJ2010-05E Eco-Drive Aqualand