Cetacea Sound Astronaut 001 Ceiling Mount Kit - Manual

Kit Contents:
1 each metal ceiling plate
1 each plastic speaker plate
4 each stainless steel machine screws.
Ceiling Installation
This kit can be used for either suspended ceiling tiles or for hard surface ceilings.
For suspended ceiling tiles:
1) Use the plastic speaker plate to mark four holes in the ceiling tile where the
Astronaut is to hang. Drill ¼" holes where these marks are located.
2) The black metal plate is used above the tile. The threaded nuts face upwards
so the flat surface of the plate fits flush to the top (inside) of the tile.
3) Use the 4 machine bolts to “sandwich” the ceiling tile. Do not over tighten,
snug will do.
4) Place ceiling tile back into the ceiling grid. Align the Astronaut speaker with
its mounting toggles and gently push the speaker flush to the plastic plate.
Once all four toggles are seated, give a very small and gentle turn clockwise
until the toggles “click” onto the speaker base. The alignment pointer is
above the face plate and should be dead center above the “hash” mark.
5) Make all further connections as required. (See separate QSG).
For hard surface ceilings:
1) Use the plastic speaker plate to mark four holes in the ceiling where the
Astronaut is to hang. Drill pilot holes for ¼" wood or metal screws.
2) Make sure to use flat-head screws so that they do not interfere with the
mounting of the Astronaut.
3) Do not over tighten, snug will do; otherwise the plastic plate may break.
4) Align the Astronaut speaker with its mounting toggles and gently push the
speaker flush to the plastic plate. Once all four toggles are seated, give
a very small and gentle turn clockwise until the toggles “click” onto the
speaker base. The alignment pointer is above the face plate and should
be dead center above the “hash” mark when properly locked.
5) Make all further connections as required. (See separate Quick Start Guide)
200901-005
If you have questions, call Technical Support at 800-556-1922.
www.cetaceasound.com
ASTRONAUT
Ceiling Mount Kit
Model #: CM001