beautypg.com

Cetacea Sound Orbiter Pairing Instructions User Manual

Orbiter, Wireless pendant microphone, Pairing instructions

background image

© 2012 Cetacea Sound Corp. All rights reserved.
Orbiter™ is a trademark of Cetacea Sound Corp.
(800) 556-1922 [email protected] www.cetaceasound.com

All audio products are proudly made in the U.S.A.
4/12

201204-007

Orbiter Pairing Instructions

1) Make sure the Orbiter pendant transmitter has been properly

charged and is NOT connected to the charger.

2) Both the transmitter and receiver must be ON in order to pair.

Note: We recommend that the receiver is not plugged into the

speaker while pairing.

3) Straighten the end of a

medium paper clip.

4) Insert the end of the paper

clip approximately 1/16" (1.5

mm) into the pairing hole on

the receiver. Use a light press

when inserting the paper clip

not to damage the hardware.

The receiver amber light will

begin to fl ash indicating that

it’s in pairing mode.

5) Insert the end of the paper clip

approximately 1/2" (1.3 cm)

into the pairing hole on the

transmitter. Use a light press

when inserting the paper clip

not to damage the hardware.

Successful pairing will result in

a solid amber light on the front

side of the receiver.

6) Receiver pairing mode lasts only a short time. If unsuccessful, repeat steps 4 and 5.

Orbiter

WIRELESS PENDANT MICROPHONE

TRANSMITTER
PAIRING HOLE

15V DC

PWR

VAR

LINE

1

2

3

ORBITER

EXT. ANT.

INPUTS

OUTPUTS

1

2

3

INPUTS

RECEIVER
PAIRING HOLE

Pairing Instructions