Dimplex SV8000 - Manual (Page 7)

7
3 Switch off the machine, empty the
collection tank and rinse clean
4 Pour cold water in to the collection tank
to fill up to the white mark and
recommence cleaning.
Maintenance
Warning: Disconnect machine from the
mains before cleaning or maintenance.
Daily maintenance
To be carried out every day or every 10
hours of operation.
1 Wash the hose by sucking one or two
litres of water from a basin into the
recovery tank.
2 Unplug the machine and wipe down with
a clean cloth.
3 Empty the collection tank, rinse and
wipe down.
4 If chemical or detergent has been used
clean the detergent tank and pump by
putting 1 litre of clean water in the
chemical tank and pump this out using
the detergent switch on the handle.
5 Remove the foam filter and the collection
tank foam panel, wash in water and refit.
• Take care not to damage the foam or filter
mesh. If either becomes torn DO NOT use
the machine and replace damaged parts
immediately.
6 Wipe down the inside of the underside of
the machine head.
7 Always wash the cleaning attachments in
hot soapy water.
Do not immerse the machine or the
hose assembly in water.
8 Wrap the cable around the handle before
storage.
Weekly maintenance
To be carried out every week or every 50
hours of operation.
As for daily maintenance plus the
following:
1 Inspect the power cord for any signs of
damage. If damaged do not repair,
contact the supplier of this product. Do
not use until repaired.
2 Inspect the Hose Assembly for any signs
of damage. If damaged do not repair,
contact the supplier of this product. Do
not use until repaired.
3 Inspect wheels and castors to ensure all
securing bolts are fully tightened.
Air purification/filtration
1 Always ensure the machine is switched
off prior to selecting the air purification
mode.
2 Remove the top cover of the collection
tank ‡ and pour clean cold water into
the collection tank up to the white mark in
the base of the tank.
3 Add in the correct quantity of fragrance to
the water in the collection tank.
4 Replace top cover.
5 Do not connect the hose assembly to the
machine.
6 Position the machine in the room to be
purified.
7 Ensure vacuum mode 1 is selected on
mode switch.
8 Plug in the machine power cord.
9 Set the vacuum power using the "Vacuum
Control" knob on top of the machine.
10 Switch on power (without fixing the hose
assembly), the "Vacuum On" light will
illuminate and "Pur" will be displayed on
the temperature display showing that you
have selected the air purification mode.
11 Leave the machine to recirculate the air in
the room.
12 On completion of the air purification
empty the collection tank and rinse clean.
Cleaning altro, vinyl, tiled
and stone floors
1 It is advisable to vacuum the floors using
a tub vacuum prior to steam cleaning.
2 Fit the extension tubes to the hose
assembly and lock in place.
3 Fit the multi-function nozzle to the tubes.
4 When cleaning tiles or stone floors fit the
universal brush fitting to the multi function
nozzle.