Denon DN-C640 - Manual (Page 13)

5
ENGLISH
1. GENERAL INFORMATION
(2) Rear panel
ANALOG OUTPUT
L
R
FIXED VARIABLE
RS232C PARALLEL
LAN
SPDIF AES/EBU
L
R
LEVEL LEVEL
R L
DIGITAL OUTPUT REMOTE
2 HOT(+)
3 COLD(-)
1 GND
SERIAL NO.
x n m . z v b , c
z ANALOG (Balanced) OUTPUT
• These are active balanced outputs using XLR type
connections. The CD's or network's audio playback
signals are output from these connectors.
• Pin layout : 1. GND / 2. Hot / 3. Cold
• Applicable connector :
Cannon XLR-3-31 or equivalent.
NOTE :
• Do not short-circuit the hot or cold pin with the
common pin.
x LEVEL Control
• Use these controls to adjust the level of the audio
signals from the BALANCED OUT connectors.
c ANALOG (Unbalanced) OUTPUT
• These are unbalanced outputs using RCA type jacks.
• VARIABLE
Use the remote control unit or web GUI to adjust the
output level.
v DIGITAL (SPDIF) OUTPUT
• This is a coaxial output using an RCA type jack.
• Signal format : SPDIF(IEC-958 Type II ) or AES/EBU
(select in menu)
• Sampling frequency : 32 /44.1 /48 /Auto (select in
menu)
b DIGITAL (AES/EBU) OUTPUT
• This is a balanced output using an XLR type jack.
1.Common / 2.Hot / 3.Cold.
• Signal format : SPDIF(IEC-958 Type II ) or AES/EBU
(select in menu)
• Sampling frequency : 32 /44.1 /48 /Auto (select in
menu)
• Applicable connector: cannon XLR-3-31 or equivalent
n RS232C connector
Connector for serial control from an external device.
m PARALLEL connector
Connector for parallel control from an external device.
, LAN connector
10BASE-T and 100BASE-TX RJ-45 LAN terminal for
network connection.
. AC inlet
Connect the included power cord here.