Caple C3400 - Manual (Page 8)

FOR THE INSTALLER
IMPORTANT
The appliance shall be installed by a QUALIFIED INSTALLATION TECHNICIAN.
The appliance must be installed in compliance with regulations in force.
The double oven is designed to fit into a cabinet of 600 mm width.
The double oven can be built in the kitchen units, but you must ensure that it is prop-
erly ventilated.
Lift the appliance into position onto the shelf, taking care NOT to lift it by the door han-
dles.
If you open the oven doors, you will see some screw holes.
The oven should then be secured to the housing by fitting screws into these holes.
Remember the housing should not be free standing but be secured to the wall and/or
adjacent fittings.
WARNING
When correctly installed, your product meets all safety requirements laid down for
this type of product category.
However special care should be taken around the rear or the underneath of the
appliance as these areas are not designed or intended to be touched and may
contain sharp or rough edges, that may cause injury.
WARNING
• We would point out that the adhesive which bonds the plastic laminate to the furni-
ture must withstand temperatures not less than 150° C to avoid delamination.
• The appliance must be housed in heat resistant units.
• The walls of the units must be capable of resisting temperatures of 75 °C above
room temperature.
• Taking care NOT to lift the oven by the door handles.
8