Caution, Electrical connection, Getting to know the appliance – Caple C195 53 User Manual
Page 5: Temperature control
CAUTION
Easy access must be provided to the appliance power socket so that it can be
unplugged if necessary. If this cannot be done, connect the appliance to the
mains (line) via a two-way switch with an opening contact of at least 3 mm,
located in an accessible place.
ELECTRICAL CONNECTION
The appliance must be by law, plugged into a socket fitted with an earth
(ground) contact. Therefore the appliance is supplied with an earthed plug that
must be plugged into a compatible socket. The manufacturer declines all
responsibility for any injuries or damage caused by the non-compliance with this
regulation.
Check the voltage shown on the specification plate located on the inner left side of the unit,
and make sure that it matches the mains voltage.
How to replace the internal lamp bulb:
Remove the power plug or switch off the main power switch of the local electric system
before replacing the bulb. Use only bulbs with a power equal to the value given on the bulb
guard (e.g. max 15W).
GETTING TO KNOW THE APPLIANCE
.
The refrigerator you have purchased, with model variations, is designed to store fresh foods
and, if supplied with a Deepfreeze compartment it can store frozen foods and freeze fresh
foods (see paragraph on freezing).
Temperature control.
The thermostat lets you regulate the temperature gradually.
•
Setting 0 means appliance off.
•
Setting 1 means minimum operation.
•
Setting 7 means maximum operation.
Remember that thermostat regulations are sensitive to variations owing to the ambient
temperature, amount of stored food, location and how often the doors are opened.
By experience you will learn the best regulation for your needs.
The space inside the refrigerator can be organized varyingly by moving the wire shelves and
solid shelves to suit your requirements. To move the shelves, lift the rear, pull them
forwards until the front slides out of the runners, turn them down and pull them out fully,
select the required position and insert the shelf by repeating the above steps in reverse
order.