Caple ST520 - Manual (Page 7)

7
MAINTENANCE
If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order
to avoid a hazard.
An accurate maintenance guarantees good
functioning and long-lasting performance.
Pay particular care to the grease filter panel.
It can be removed by pushing its special han-
dle toward the backside of the cooker hood
and turning the filter downwards so to unfa-
sten it from its slot. To insert the filter just
perform the opposite operation.
After 30 hours working (SL903-P and SL
EM903-P), the push button control panel will
signal the saturation of the grease filter by
lighting all the buttons.
Press the timer button to reset .
The grease filter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
* In case the appliance is used in its filtering
version, the active charcoal filter
needs to be periodically replaced. The
charcoal filter can be removed by removing the
grease filter first, and by pulling its special
plastic tongue until it is unfastened from its
slot. Reinsert the charcoal filter by operating
in the opposite way. The charcoal filter needs
replacing depending on the use, but however
every six months at least.
To clean the appliance itself tepid water and
neutral detergent are recommended, while
abrasive products should be avoided.
To replace the halogen lamps, remove first
the glass blocking ring (Fig. 6A), by leve-
ring with a screwdriver and thus removing
the opaque glass (Fig. 6B) - when performing
this operation hold the opaque glass careful-
ly. Remove the lamp (Fig. 6C) without tou-
ching it with uncovered hands. Replace it with
another lamp of the same kind. After the re-
placement, re-insert the glass blocking ring
and fasten it.