Caple ST520 - Manual (Page 5)

5
If the appliance is not provided with a non-
separable flexible cable and plug, or with
another device ensuring omnipolar discon-
nections from the grid, with an opening di-
stance between the contacts of at least 3 mm,
then such disconnecting devices must be
supplied within the fixed installation. If the
fixed appliance is endowed with a supply
cord and a plug, the appliance has to be
put in a place where the plug can be rea-
ched easily.
* The use of materials which can burst into
flames should be avoided in close proxi-
mity of the appliance. When frying, please
pay particular attention to fire risk due to oil
grease. Being highly inflammable, fried oil is
especially dangerous. Do not use uncovered
electric grills. In order to avoid possible fire
risk, all instructions for grease filter cleaning
and for removing eventual grease deposits
should be strictly followed.
Before installing the appliance, make sure
that none of the parts are damaged in any way.
In case of damaged parts, contact your retai-
ler and do not proceed with installation.
Read all of the following instructions with
care before installing the appliance.
- Use an air outlet pipe of the shortest pos-
sible length.
- Limit the number of pipe bends.
- Use a material approved by standards and
regulations.
- Avoid any sudden changes in pipe section
(recommended constant diameter: 150 mm
or equal surface area).
WARNINGS
The appliance is not intended for use by
young children or infirm persons without
supervision. Young children should be su-
pervised to ensure they do not play with
the appliance.
* The cooker surface and the interior part
of the cooker hood must be at a minimun
distance of 65 cm.
* The air sucked can’t be conveyed throu-
gh or into a duct used to let out fumes
from appliances fed by energy other than
electric power (eg. central heating, radiators
water-heaters, etc.).
* To evacuate the air outlet, please comply
with the pertaining rules given by compe-
tent authorities.
* Provide the room with an adequate aeration
when a cooker hood and appliances fed by
energy other than electric power (gas-, oil-,
or coal- stoves, etc.) are used simultaneously.
The cooker hood, when evacuating the sucked
air, could generate a negative pressure in the
room- which can’t exceed the limit of 0.04
mbar, in order to avoid the suck of exhausts
deriving from the heat-source. Therefore the
room should be provided with air-intakes to
allow a costant flow of fresh air.
If the rating label in the cooker-hood
shows the symbol , the appliance is
built in class II° and it does not need any
earth connection.
If the rating label in the cooker-hood does
not show the symbol , the appliance is
built in class I° and it needs the earth con-
nection.
* When performing the electrical connections on
the appliance, please make sure that the current-
tap is provided with earth connection and that
voltage values correspond to those indicated on
the label placed inside the appliance itself.
Before carrying out any cleaning or maintena-
nce the appliance needs to be disconnnected
from the electric supply.
.
USES
The appliance is already arranged both for
filtering and for ducted performances.
* In its filtering version the air and fumes
conveyed by the appliance are depured both
by a grease filter and by an active charcoal filter.
In its ducted version fumes are directly con-
veyed outside, through an evacuation duct
connected with the superior part of the wall
or the ceiling. Charcoal filters are not necess-
ary in this case.