Caple VE550BK - Manual (Page 7)

Standard configuration
If two cookerhoods-radiocontrol system are
installed in the same room or in the immediate
vicinity, each system may affect the operation
of the other, due to the fact that they have the
same code. Therefore it will be necessary to
change the code of one of the radio controls.
Warning:
The battery should be replaced every year
to guarantee the optimal range of the tran-
smitter. To replace the exhausted battery,
take the plastic lid off, remove the battery
and replace it with a new one, observing
the correct battery polarities. Used batte-
ries should be discarded in special collec-
tion bins.
Emergency button:
In case of radio control misfunctioning, to
switch off the appliance just press the emer-
gency button (Fig. 7) placed near the lighting
lamp. After fixing reset the emergency but-
ton.
The luxury products are endowed with an
electronic device which allows the automatic
switching off after 4 hours working from the
last operation.
Generating a new transmission code
The radiocontrol is supplied by the manu-
facturer with default codes stored. If you
want to create a new set of codes, proceed
as follows:press and hold the UP, STOP and
DOWN buttons simultaneously for 2 secon-
ds. Afterthe LEDS light up, press the UP and
DOWN button swithin 5 seconds. The LEDS
will flash 3 times to indicate that the process
is completed.
WARNING: This procedure deletes all pre-
viously stored codes.
Learning the new transmission code
After changing the transmission code on
the radio control, the cooker hood electro-
nic control unit must be made to set the new
code as follows: Disconnect the appliance
from the electric network and then re-con-
nect it ; press the light key within the
next 15 seconds, in order to synchronize the
cooker-hood with the new code.
7
WORKING
Remote control for cooker hood remote fig.
6.
Technical data:
Alkaline battery powered: 12v mod. 23A
Operating frequency: 433.92 Mhz
Combinations: 4096
Max. consumption: 25mA
Operating temperature: -20° : +55°C
- To light the cooker hood on or to
light it off press the button:
- To increase the speed up to the
fourth one press the button:
- To reduce the speed up to the
second one press the button:
- To go from a high speed back to
the first one press twice the button:
- To give power to the lights or to
shut them down press the button:
- To set the timer up press the
button:
The LED on the right side will start to flash
(every 5 seconds), the hood will work for 10
minutes at the selected speed and then it
lights automatically off. If the client increases
or reduces the speed while the timer is on,
this is automatically stopped.
Remark: At every selected function, the LED
lights on accordingly.