Caple 1MINCH6 - Manual (Page 7)

Important:
The wires in this mains lead are colored in accordance with the following
code:
Blue Neutral
Brown Live
As the colors of the wires in the mains lead of this appliance may
correspond with the colors markings identifying the terminals in your spur
box, proceed as follow:
The wire which is colored blue must be connected to the terminal which is
marked with the letter “N” or colored black. The wire which is colored brown
must be connected to the terminal which is marked with the Letter ‘L’ or
colored red.
WARNING
This appliance has such technical particulars that it belongs to Class 2
insulation and therefore neither wire should be connected to the terminal
marked with the letter E or by the earth symbol.
Light bulb doesn’t come on
A replacement is probably necessary, But check first that the bult
is firmly screwed in to its holder. If the filament is broken,
remember that the light bulbs are not covered by our guarantee.
Remember to disconnect power supply before removing the bulb.
Motor is on but fan doesn’t seem to be as efficient as usual
Check grease filter. If it hasn’t been cleaned recently, It might be
clogged with grease. If filter is relatively clean, check charcoal
filters. If this hasn’t been replaced for more than six months.
Remove and replace a new one. As charcoal filters is just the
same way as the grease filter, thereby reducing the efficiency of
both the fan and the filter itself.
Works normally but cooking smells linger
If you’re using the unit in re-circulation mode, change charcoal
filter. It is obviously past its prime.
Controls fail to switch motor no
Check plug, socket and fuse. If these are in order and fault
persists, it could be that an accumulation of grease has impaired
the efficiency of the switch mechanism. Try rapidly moving switch
Electrical Connections Not working Properly ?
P10 P11