Caple 1MINCH6 - Manual (Page 3)

Once the grill has been removed, The front door panel should also be
removed.
Open the front panel and remove the two screws (B) as illustrated above.
Press the tab (C) down and remove the front panel from its guides
Secure brackets(D) onto the top of the extractor using the fitting
screws and washer (E).Check that adjustment screw (F) is fitted.
Note: Note some units may have bracket fitted.
Ensuring there is a minimum distance if 65cm between the bottom of the
extractor and hob surface. Then fix the two mounting brackets (G) to the
rear wall.
Once the two mounting brackets are in position hook the extractor
mounting bracket (D) onto the wall mounting bracket
Some adjustment is provided within the brackets. For forward and
backward adjustment use screw (E) and for height alignment adjusts
screws (F).
Once the adjustment is complete fully tighten all screws.
If after installation there is a gap between the rear wall and the extractor
a spacer is provided. This can be fixed to the rear of the extractor and
cut to accommodate the gap.
IMPORTANT NOTE: After the extractor has been positioned correctly
the extractor must be fixed to the adjacent through the fixing holes in the
sides of the extractor.
All that remains is to fix the front wooden door panel to the extractor by
using the diagram below fix the front panel
Extraction Without Intrusion Cont.. Extractor Without Intrusion cont..
P2 P3