Caple SP610BK - Manual (Page 10)

1. Remove the grease filter and the charcoal filter (if fitted).
2. Remove the fat collector and clean it in warm water with washing up liquid. It can
also be cleaned in a dishwasher.
 DO NOT let dirt build up on the hood
 DO NOT use steel wool or steel brushes to clean the hood
 DO NOT leave salt solutions, disinfectants, bleaches or cleaning compounds on
the hood for any length of time as they may damage the stainless steel. Rinse
after use with clean water and wipe dry with a clean cloth.
Replacing the bulbs
Depending on your model of hood, there are two possible types of lighting, halogen and LED. The
illumination is designed for use during cooking and not for prolonged general illumination of your kitchen.
Prolonged use of the lights may reduce the life time of the bulbs.
WARNING: Do not touch or change light bulbs while the hood is operating. Wait until
the bulb has cooled before removing.
Use only the same bulbs as the original specification. Replacement lights are available through the dealers.
Halogen and LED Lights.
With the grease filter removed, from inside the hood press the light fixture out of its mounting bracket.
Unplug the light from the wiring harness. Avoid direct contact between the lense and your hands.
Replace the damaged lamp by reversing the steps. Snap in place.
Replace the bulbs as follows:
1.
Lift up and remove the light fitting with a screwdriver or other suitable tool.
Emptying and cleaning the fat collector (For these hood fitted with fat
collector)
The fan is fitted with a fat collector that collects fat from the fan blades and fan housing.