Campomatic Window AC - Manual (Page 12)

O
45
Scrape
5-
10
m
m
Less than C
more than D
More thanA
More than B
Less than
more thanA
Wall thickness is less than C
If the wall thickness is more than
scrape the wall as shown above.
Make rear side lower so that water will drain
out smoothly.
C
C
Size(mm)
A
B
C
D 400
500
210
60
INSTALLATION(CONTINUED)
The Treatment of Condensed Water
To meet different requirement of different type of air conditioner, there are two kinds of methods
for your choice to treat the condensed water. You can choose back drainage or non-drainage.
See the following procedures to perform back drainage:
1. Fit the seal onto the drain joint (which provided with
your air conditioner accessory).
2. Remove the rubber plug from the back of the unit.
(If applicable),and insert the rubber plug(which
provided with your air conditioner accessory)
into the bottom drain hole of the unit.
3. Attach the drain joint to the back of the cabinet
where you remove the plug and rotate 90 to securely
assemble them.
4. Connect the drain joint with a extension drain hose
(Locally purchased)
O
SEAL
DRAIN
JOINT RUBBER
PLUG
Note: If you choose non-drainage,both the bottom and the back drain hole of the unit should be
inserted with the rubber plug.
9 9