Campomatic TL10E User Manual

Page 13

The wash stops

Programme selection

Install the washing

machine

measure out the

detergent

Plug the power supply

Select the desired

programme

Put down (hang up)

the drain pipe

Close the

machine door

Press the

[start/pause] key

When the wash stops,

the buzzer will buzz continuously for 6 times and

then the power will be automatically cut off.

Turn off the water tap

Although the power can be cut off automatically, the power plug must be pull
out for the safety.

Press the POWER button.

press the start/pause key.

Select the proper water level and other attached functions

Load the laundry

Instruction of the NORMAL program

Instruction to single wash procedure

Steps in details

1.Press the power switch.
2.According to the washing amount choose the proper water level.
3.Press START/PAUSE button.

1.Close the lid of the door when machine is running, otherwise, it will automatically
stop working during spin process and send out abnormal warning.
2.The washer will not work when the filled water does not reach the set water level.
3.The selection of rinse water level: the level is equal to wash water level.
Press [Rinse Level] button, the indicator light which stand for rinse level flickered.
User can select the rinse water level according to needs. Rinse level exceed that
wash level all the time. It shows the wash level if not press this button. And only
show rinse level when rinseing.
4.After pressing down [ Power Switch ], if the [Start / Pause ] button is not pressed,
the power will be automatically cut off in 10 minutes.

1.[Normal] wash program is the easiest, most convenient and most common washing
program. When the user press the power switch and then press [Start/Pause] button,
the normal washing program will start to work.
2.When the washer start to work, the digital tube show the remain time. The indicator
light which stand for remaining time is flickering.

1.User may freely select any single procedure, or any combination of procedures
among WASH, RINSE and SPIN according to the actual requirements. It is only
required to turn off any one or two of these three indicators that not needed by the
user. And keep the indicator be on showing the process needed by the user.
2.Single wash -- after switching on the power, turn off RINSE and SPIN two indicators
by pressing these two keys. The operation for single rinse and single spin is similar.
3.Single wash-spin – after switching on the power, turn off RINSE indicator by pressing
that key. The operation for single rinse-spin and single wash-rinse is similar.

NOTICE

！

Quick start

The main wash

Use the cleaning solution for twice

1. Put the laundry in the first batch and wash powder and press “Function” button to set
single “wash” to run.

2. Take out the laundry in the first batch after hearing the buzzing sound.
3. put in the laundry in the second batch, and run “ Wash”, “Rinse”, “Spin”.
4. Take out the laundry in the second batch after hearing the buzzing sound.
5. Put in the laundry in the first batch and press “ Function” button to run “Rinse” and “Spin”.

6 Turn on water supply