Campomatic KOCVBI - Manual (Page 16)

15
Please rinse in time if there are residues left in door seal or on front panel. Do not use rough cleaning tools like
hard brush, coarse cloth, wire netting, knife or any other sharp tools, using those sharp tools may scratch door seal or
the surface of the front panel. Please use non-abrasive detergent. You can use wooden or plastic cleaning tools if it is
necessary.
10.7 Cleaning the accessories
Clean the accessories after each use. If they are very dirty, soak them first of all and then use a brush and
sponge. The accessories can be washed in a dish washing machine.
Make sure that the turntable plate and the respective support are always clean. Do not switch on the oven unless
the turntable and the respective support are in place.
11. SPECIAL MAINTENANCE
11.1 Replacing the light bulb
Concrete operations:
Take off the plug from power supply.
Take off the lampshade（1）
Take down halogen lamp（2）；Warning: Hot lamp！
Fill new halogen lamp (230V25W).
Operate according to the instruction.
Install lampshade well.
Connect the power.
WARNING: The lamp is not suggested for consumer
to replace. The replacing should be done
by a professional mechanic.
12. INSTALLING THE APPLIANCE
12.1Before the installation
Open the oven door and take out all the accessories and remove the packing material.
Make sure that the oven is not damaged by any way. Check that the oven door closes correctly and the inside of
the door and front oven panel are not damaged.
12.2 DO NOT USE THE OVEN
If the power cable or the plug is damaged, if the oven does not function correctly or if it has been damaged or
dropped. Put the oven on a flat and stable surface. The oven should not be installed close to any heat source, radios
or televisions.
During installation, make sure that the power cable does not come into contact with any moisture or objects with
sharp edges and the back of the oven. High temperature can damage the cable. Warning: after the oven is installed
you should make sure you can access the plug.